SICE S 65 E Manual De Instrucciones página 97

- : every time the ENTER key is pressed, the machine automatically modifies
the type of balancing programme (shown on the display) in the following sequence:
DYNAMIC-ALU1-ALU2-ALU3-ALU4-ALU5-STATIC-DYNAMIC MOTORCYCLE-ALU MO-
TORCYCLE.
- : by pressing the
- Pressing the
ment, maintaining the previous width.
- in this phase, it is possible to perform a new acquisition of the rim planes.
- lowering the guard confirms the selection that was made (manual width entry or wheel
type selection) and the width scanning and spin are performed.
Note:
- automatic width acquisition is re-enabled only with a new acquisition of the automatic
internal measuring arm;
- if the wheel guard is closed or in the case of a fault of the sensor located on the guard,
the machine will automatically set up for manual width entry when the internal measur-
ing arm is moved to the rest position;
- at the end of the spin, it is possible to change the width acquired automatically by the
machine by selecting the following icon on the work page
IMPORTANT
bear in mind that the wheel's nominal diameter (e.g. 14") refers to the planes on which
Operator's Manual S 65 E - S 65 E C
dimensions key, manual width insertion is enabled;
button during the indicated phase returns to the working environ-
:
97