SICE S 65 E Manual De Instrucciones página 101

These programmes are used for maximum precision balancing of light alloy rims that
require both weights to be applied on the same side (inner) in relation to the rim disk.
This type of wheel balancer is particularly suitable for application of adhesive weights on
the rim, thanks to the forward position of the wheel in relation to the body, which allows
a large zone on the inside of the rim to be accessed freely.
Wheel data acquisition
Geometric data relating to the actual balancing planes rather than the rated wheel data
(as in standard ALU programmes) have to be set. The balancing planes where the adhesive
weights are to be applied may be selected by the user according to the specific shape of
the rim. However, bear in mind that it is always preferable to select balancing planes as
far apart as possible in order to reduce the quantity of the weight to be applied; if the
distance between the two planes is less than 37 mm (1.5"), the A 5 message is displayed.
Move the end of the automatic measuring arm in line with the plane selected for the
application of the inner weight. In ALU 1P, the reference of the weight mid-point is the
centre of the gripper cavity.
Centre of the weight-holder gripper cavity
ALU 1P
Operator's Manual S 65 E - S 65 E C
ALU 1P and ALU 2P programmes
18
Centre of the gripper cavity without
weight-holder
18a
101