Balancing Programmes - SICE S 65 E Manual De Instrucciones

BALANCING PROGRAMMES

Before starting a balancing operation, the following steps must be followed:
- mount the wheel on the hub using the most suitable centring system;
- make sure that the wheel is locked correctly to the shaft so that no displacement can
occur during the spin and braking phases;
- remove any counterweight, pebble, dirt or other foreign body;
- set the wheel's geometric data correctly.
The balancing programmes are grouped within the balancing programmes icon in the
main working screen.
Select the icon and press the keypad Enter button.
The following balancing programmes are available:
Dynamic balancing (standard)
This balancing mode is the most commonly used one and the wheel balancer consid-
ers it standard; if a different balancing programme is being used, select the balancing
programme icon.
The following video page relating to this programme appears on the screen.
17
Now proceed as follows:
1. Set the wheel's geometric data.
2. Spin the wheel lowering the guard or by pressing the START key and the button in the
Operator's Manual S 65 E - S 65 E C 99