SICE S 65 E Manual De Instrucciones página 133

The automatic measuring devices are not working
The sensors were not in the rest position when switching on the machine and the Enter
button was selected, disabling control of the automatic sensors.
Switch the machine off, bring its sensor into the correct rest positions and switch
➥
the machine back on.
The automatic arm laser line does not work (if present)
Battery to replace, proceed as follows:
- Remove the four screws in the lever (A,
Fig.31) and then remove the plastic cover
(B, Fig.31)
- Remove the card (C, Fig.31) present inside it
- Replace the battery in the card with a new
3V CR2450;
- Proceed with the assembly of the lever
in the opposite direction to disassembly.
CAUTION
Pay attention to the positioning of the cables
inside the recess of the lever to avoid ac-
cidentally damaging the cable itself when
closing the plastic casing.
If the laser line does not work with the new battery, call for technical assistance.
START has been pressed and the wheel fails to spin (the machine
The wheel guard is raised (the "A Cr" message is displayed).
- Lower the guard.
The wheel balancer provides unsteady unbalance values
The machine was jolted during the spin.
➥ Repeat the spin, avoiding any unnecessary strain during the acquisition procedure.
The machine does not firmly rest on the floor.
Check that the machine stands evenly on a stable surface
➥
The wheel is not locked correctly.
Tighten the clamping ring-nut firmly.
➥
Several spins are to be performed to balance the wheel
The machine was jolted during the spin.
➥ Repeat the spin, avoiding any unnecessary strain during the acquisition procedure.
The machine does not firmly rest on the floor.
Check that the supporting surface is firm and stable.
➥
The wheel is not locked correctly.
Tighten the clamping ring-nut firmly.
➥
Operator's Manual S 65 E - S 65 E C
does not start)
31
133