SICE S 65 E Manual De Instrucciones página 102

ALU 2P
In ALU 1P, the balancing plane is about 15mm further back (weight mid-point) from the
point where the measuring head touches the rim (fig.18/18a).
In ALU 2P the reference is the rim edge, as the inner weight is of the traditional spring
type (fig.15).
Pay maximum attention when the end of the arm is being placed in an area of the rim free
of discontinuity, so that the weight can be applied in that position.
- Keep the arm in position. After two seconds the machine emits an acoustic confirmation
signal to indicate that the distance and diameter values have been acquired.
- Move the end of the automatic measuring arm in correspondence with the plane selected
for the application of the outside balancing weight (fig. 19/19a), in the same manner as
described previously for the inner side.
- Keep the arm in position and wait for the acoustic confirmation signal.
- Return the measuring arm to the rest position. Automatically the machine will set up in
the ALU P balancing programmes (FSP programme).
- Perform a spin.
- At the end of the spin, if you want to change the balancing programme set automatically
by the machine (FSP), select the balancing programme button and press ENTER until
the required programme is selected.
Applying balancing weights. (Fig. 20)
• Adhesive weights applied with a weight-holder device (if available), after modifying the
application position from 12 o'clock to CLIP in the "Adhesive weight application position"
set-up menu
- Select the plane where the first balancing weight is to be applied.
- Rotate the wheel until the central element of the corresponding position indicator lights
up.
If the weight to be applied is a conventional clip type (inner side in ALU 2P), apply it on
the corresponding 12 o'clock position. If the weight to be applied is instead the adhesive
type and the weight-holder device is installed, proceed as follows:
102
19
Operator's Manual S 65 E - S 65 E C
19a