Publicidad
TROUBLESHOOTING
your dealer to carry out repair work.
e
Insert plug securely into outlet.
e Turn on power to other component.
Power plug is disconnected from outlet.
e The component power plug has been plugged
into another component power outlet (e.g.
timer, etc.) but power to that unit is discon-
nected.
No power supplied to unit.
Connect securely.
Connecting cords are disconnected from termi-
nals, or connected incorrectly.
e Terminals, or connecting cords pin plugs are
dirty.
e The TAPE 2 MONITOR switch ® is set to ON
(except when using an adaptor component).
Operation of other components is incorrect.
No sound.
Clean terminals and plugs.
e Set switch @ to OFF.
e Consult the operating instructions for the other
components.
e Set one switch or both switches to "ON".
e Both SPEAKERS
selector switches are set to
"OFF" (A-203 only)
e The position of the Input Selector (2) does not
match the component to be played back.
e Set the switch ® correctly (CD, PHONO,
TUNER, TAPE
1/DAT).
Connect securely.
Connecting cords or speaker cords are discon-
nected on that side.
BALANCE
control is set to one side.
j
No sound from one speaker.
Set BALANCE
control to center position.
e Reconnect properly.
e Consult the operating instructions for the cas-
sette deck.
Set the TAPE 2 MONITOR switch @ to OFF.
e Connections are incorrect.
e Operation of cassette deck is incorrect.
Cannot record tapes.
The TAPE 2 MONITOR switch (O is set to ON.
Set switches correctly
The positions of the Input Selector switch (2)
(See section COPYING TAPES).
and TAPE 2 MONITOR switch (O are incorrect
(when using 2 cassette decks).
Operation of cassette decks is incorrect.
Cannot perform tape copying.
e Consult the operating instructions for the cas-
sette decks.
20
<ARE1302>
En
Publicidad
