SICK WTT12-S Instrucciones De Funcionamiento página 23

5 Transport and storage
5.1 Transport
5.2 Unpacking
5.3 Transport inspection
5.4 Storage
8029123/2024/01/15 | SICK
Subject to change without notice
NOTICE
Damage due to improper transport!
The product must be packaged with protection against shock and damp.
■
Recommendation: Use the original packaging.
■
Note the symbols on the packaging.
■
Do not remove packaging until immediately before you start mounting.
■
• To protect the device against condensation, allow it to equilibrate with the ambient
temperature before unpacking if necessary.
• Handle the device with care. Protect it against mechanical damage (e.g. to the
front screen).
•
To avoid ingress of dust and water, only remove the protective elements, for
example the protective caps of the electrical connections, just before attaching the
connecting cable.
Immediately upon receipt in Goods-in, check the delivery for completeness and for any
damage that may have occurred in transit. In the case of transit damage that is visible
externally, proceed as follows:
• Do not accept the delivery or only do so conditionally.
• Note the scope of damage on the transport documents or on the transport compa‐
ny's delivery note.
• File a complaint.
NOTE
Complaints regarding defects should be filed as soon as these are detected. Damage
claims are only valid before the applicable complaint deadlines.
Store the sensor under the following conditions:
• Recommendation: Use the original packaging.
• Do not store outdoors.
• Store in a place protected from moisture and dust.
•
Do not expose to any aggressive substances.
• Protect from sunlight.
• Avoid mechanical shocks.
• Storage temperature:
• Relative humidity see "Data sheet", page
• For storage periods of longer than 3 months, check the general condition of all
components and packaging on a regular basis.
see "Data sheet", page 30.
30.
O P E R A T I N G I N S T R U C T I O N S | WTT12-S
OPERATING INSTRUCTIONS
en
23