Tunturi R-85W Manual Del Usuario página 18

English
Explanation Display functions
Time
- Without setting the target value, time will count up.
- When setting the target value, time will count down
from your target time to 0 and alarm will sound or
flash.
- Without any signal being transmitted into the
monitor or 4 seconds during workout, time will
STOP
- Display range:
- Target range:
Time/ 500M
Shows the time needed to run a 500 meter distance
workout, based on the current rowing intensity.
Distance
- Without setting the target value, distance will count
up.
- When setting the target value, distance will count
down from your target distance to 0 with an alarm
sound or flash.
- Display Range 0~9999
- Target Range 10 ~ 9990 ( ± 10 )
Calorie
- Without setting the target value, calorie will count
up.
- When setting the target value, calories will count
down from your target value to 0 with an alarm
sound or flash.
- Display range: 0~9990.
- Target Range 10 ~ 9990 ( ± 10)
NOTE
• This data is a rough guide for comparison of
different exercise sessions which cannot be used
in medical treatment
Pulse
- Current pulse will display ater 6 seconds when
detected by the console.
- Without any pulse signal or 6 seconds, console will
display "P".
- Pulse alarm will sound when current pulse is over
the target pulse.
- Range: 0-30 ~ 230 BPM
SPM
- SPM is Strokes Per Minute and is showing the
avarage Strokes per minute during workout.
- Display range:
Strokes
- Without setting the target value, strokes will count
up.
0:00~99:59
0:00~99:00 (± 01:00)
0 ~ 999
- When setting the target value, strokes will count
down from your target distance to 0 with an alarm
sound or lash. (During countdown "Remaining" is
shown )
- Display range:
- Target range:
Total Strokes
- Will display the total strokes of all workouts.
- This value cannot be reset, other than by changing
the batteries.
- Display range:
-
Explanation of buttons
Set
- Press SET button to select unctions:
MANUAL, INTERVAL, TARGET
- Press SET button to increase value. Press and hold
the button to increase value faster.
- TIME setting range: 00:00~99:00
- STROKES setting range: 0~9990
- DIST setting range: 0~9990
- CAL setting range: 0~9990
- PULSE setting range: 30~230
Mode
- Press mode button to select console functions.
- In operational mode, press Mode to Stop/ Pause
the workout.
- In Stop mode, press Mode button to contineu
workout.
Reset
- In setting mode, press RESET key once to reset the
current function figures.
- In STOP mode, press "RESET" button once to reset
workout mode and return to programming mode.
- Press RESET key and hold or 2 seconds to reset all
function figures, and reboot console.
Operation
Power on
- Press any key to power on the console when being
in sleep mode..
- Start workout to power on the console when being
in sleep mode.
Power off
Without any signal being transmitted into the monitor
or 4 minutes the monitor will enter SLEEP mode
automatically. ( Active training data will be lost )
1 8
0 ~ 9999
10 ~ 9990 (± 10)
0 ~ 9999
(±1:00)
(± 10)
(± 10)
(± 10)
(± 1)