Publicidad
Idiomas disponibles
Idiomas disponibles
SP-900-Install.book Seite 31 Montag, 25. Januar 2010 4:53 16
CoolAir
1.1
Using the device
Only use the air conditioner for the purpose specified by the manufacturer
and do not make any alterations or structural changes to the device.
Only operate the air conditioner if you are certain that the housing and
the cables are not damaged.
Installation, maintenance and repair work may only be carried out by
qualified personnel from a specialist company who are familiar with the
risks involved and the relevant regulations.
Do not use the air conditioner near flammable fluids or in closed rooms.
Do not reach into air grilles or ventilation nozzles or insert any foreign
objects in the system.
Do not open the system in the event of a fire. Use approved
extinguishing agents instead. Do not use water to extinguish fires.
Switch off the air conditioner before using automatic washing equipment
(automatic car washes etc.) to clean the vehicle.
Disconnect all connections to the power supply when carrying out work
on the device.
The system must be switched off before you tilt the cab.
1.1.1 Handling electrical cables
The electrical cables might be laid over sharp edges. Use ducts or
tubes to prevent damage.
Do not lay loose or bent cables next to electrically conductive materials
(metal).
The electrical power supply may only be connected by a
qualified workshop.
Safety instructions
31
Publicidad
