Dometic WAECO CoolAir SP-900 Instrucciones De Instalación página 40

SP-900-Install.book Seite 40 Montag, 25. Januar 2010 4:53 16
Installation
The connection lines should be installed at right angles to the rear panel
of the lorry (see Fig. 12 on page 7). For this purpose, use body adhesive
(e.g. Betalink K1) and a self-tapping screw to fasten the holders (see Fig.
13 on page 7).
➤ Use the supplied holders to fasten the connection line to the rear panel
of the lorry.
➤ Loosen the two screws on the cap of the control electronics and
remove the cap (see Fig. 14 on page 8).
➤ Install the electrical cables for the control electronics.
➤ Connect the electrical cables according to the following wiring table
(see Fig. 16 on page 10):
No. in fig. 15 Designation
Item no. in
fig. 15
4441300096
4441300108
4441300097
➤ Use cable ties to protect the electrical cables from rubbing and damage.
40
I
1 Compressor with control unit
2 Condenser fan
3 Control unit
4 Room sensor
5 Vaporiser fan
6 Control unit bus cable
7 Condenser fan connection cable
8 Power cable
No. in fig. 16 Parameter
1 Connection cable (condenser fan)
2 Bus cable (control panel/control electronics)
3 Main connection cable
CoolAir