DANGER CAUSED BY ELECTRIC CURRENT
WARNING!
Contact with live cables or components can be fatal !
Please observe the following safety instructions in order to prevent an exposure to electric
current:
Do not use the unit if the mains cable or plug are damaged.
●
In this case, have a new connection cable installed by GRAEF Customer Service or an
●
authorised specialist before continuing to use the unit.
By no means open the housing of the unit. There is a risk of electric shock if live connections
●
are touched or if the electrical or mechanical structure is changed.
Never touch live parts. This can cause an electric shock and even death.
●
SAFETY INSTRUCTIONS FOR THE ELECTRICAL CONNECTIONS
For safe and fault-free operation of the unit, the following requirements have to be met during
the electrical connection:
Before connecting the unit, compare the connecting data (voltage and frequency) on the
●
type plate with those of your energy network. This data must match to prevent damage to
the unit. If in doubt, consult a qualified electrician.
The socket outlet must be protected by at least a 10A circuit breaker.
●
Make sure that the power cable is not damaged and is not laid across hot surfaces or sharp
●
edges.
The connecting cable must not be stretched tightly.
●
The electrical safety of the unit is guaranteed only if it is operated on a properly installed
●
power supply. If in doubt, have the in-house installation checked by a qualified electrician.
The manufacturer shall not assume responsibility for damage which has been caused by
absent or interrupted protective conductor.
UNPACKING THE UNIT
When unpacking the unit, proceed as follows:
Remove the unit from the box.
●
Remove the packaging parts.
●
CAUTION!
Danger of injury !
The very sharp blade can cause injuries.
Remove any stickers on the unit (do not remove the type plate).
●
32