Graef MYtiny Manual De Instrucciones página 43

TROUBLESHOOTING
Problem
Adjustment of the cutting
thickness cannot be turned.
Unit cannot be switched on.
The slide is blocked and
cannot be moved all the
way.
The slide is stiff.
The slide squeaks when
moving.
The cutting table cannot be
snapped shut.
Grinding noises on the
blade.
Cause
The switch-on safety device
is active.
The switch-on safety device
is active.
For safety reasons, the thumb
guard must be in the vertical
position during operation.
The slideway is dirty.
The thumb guard rubs
against the lower edge of
the cutting table.
For safety reasons, it is only
possible to snap shut the
cutting table when the limit
stop is completely closed.
The slide is not pulled out far
enough; the hand rest hits
the limit stop.
Food residues on the blade.
Solution
Press the safety button and
turn the adjustment of the
cutting thickness.
Press the safety button and
turn the adjustment of the
cutting thickness.
Turn the thumb guard to the
vertical position until it clicks
into place.
Clean and grease the
slideway.
Turn the thumb guard to the
vertical position until it clicks
into place.
Close the limit stop comple-
tely until the safety button
engages.
Pull the slide forwards until
the hand rest is in front of
the unit.
Remove the blade and
clean it thoroughly. Subse-
quently grease according
to the instructions.
DE
EN
FR
NL
IT
ES
DK
PL
HU
SV
NO
RU
UK
43