Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the Charging Station
Parts Required
1
4
1
1
A power supply plugged into a non-GFCI or non-RCD receptacle could result in
electric shock.
Plug the power supply into only a ground-fault circuit interrupter (GFCI) or residual-
current device (RCD) receptacle with a tripping current not more than 30 mA.
A malfunctioning or damaged charging station, low-voltage cable, or power supply
could overheat and cause an increased risk of fire.
Do not install the charging station, low-voltage cable, or power supply near
flammable or combustible materials.
If the power supply to the charging station is malfunctioning or damaged, disconnect
the power supply, and contact an Authorized Service Dealer to replace it.
Check to ensure compliance with all codes and regulation before mounting the power
supply.
Mounting the power supply may require additional materials and/or hardware,
depending on the type of base material present at your chosen mounting location.
Route the power cord to the charging station outside of the mowing area; otherwise,
the mower may damage the cord.
1. Mount the power supply to your structure at a minimum height of 30 cm (12 inches).
Note:
cable.
Setup: Installing the Charging Station
Charging station
Allen-head screw
Low-voltage cable
Power supply
Ensure that the power-supply cord has enough slack to plug into the low-voltage
WARNING
WARNING
IMPORTANT
IMPORTANT
Page 4–14
3448-238 C
Publicidad
