Toro Haven Robotic 3000 m2 Manual De Instrucciones página 61

The mower does not start a mowing cycle.
The on/off switch underneath the mower is
in the O
FF
The handle is still installed in the mower.
The mower is stuck on an object.
The mower is pushed up against an object.
The mower is on too steep of an incline.
The mower is locked.
Mower impacts object, will not change direction.
There is an obstruction between the shroud
and the chassis.
The mower will not move.
There is mud or grass built up on the drive
wheels.
3448-238 C
Possible Cause
position.
Possible Cause
Possible Cause
Troubleshooting
Push the on/off switch to the O
Remove the handle from the mower and
stow the handle in the charging station.
Move the mower away from the object.
Move the mower away from the object.
Place the mower on an incline of 25° or
less.
If the lock/unlock indicator light is
illuminated on the control panel, enter your
PIN on the keypad, then press the play
(resume operation) button or the home
button.
Remove the obstruction between the
shroud and the chassis.
Clear the mud or grass from the drive
wheels until the tread on the drive wheels
are exposed.
Page 8–1
Chapter 8
Corrective Action
position.
N
Corrective Action
Corrective Action
Troubleshooting