Descargar Imprimir esta página

Toro Haven Robotic 3000 m2 Manual De Instrucciones página 9

Publicidad

Idiomas disponibles

Idiomas disponibles

General Safety
• The operator/supervisor of the machine is responsible for any accidents or hazards
occurring to others or their property.
• Read, understand, and follow all these instructions and warnings before using the
machine.
• Improperly using or maintaining the machine could result in serious injury or death. To
reduce this potential, follow all safety instructions.
• Do not allow children or untrained people to operate or service this device. Allow only
people who are responsible, trained, familiar with the instructions, and physically capable
to operate or service the device.
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
In order to maintain compliance with the FCC RF exposure guidelines, this device should be
installed and operated with a minimum distance of 20cm between the radiator, and the body
of the operator and/or nearby persons.
Any change or modification not approved by the party responsible for compliance could void
the user's authority to operate this device. Permitted Low Gain Dipole Whip Antenna (2dBi).
IC Statement - IC: 3575A-SCG
1. Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry
Canada. To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more
than that necessary for successful communication.
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut
fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour
l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage
radioélectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne et son
gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas
l'intensité nécessaire à l'établissement d'une communication satisfaisante.
2. This radio transmitter has been approved by Industry Canada to operate with the antenna
types listed below with the maximum permissible gain and required antenna impedance for
each antenna type indicated. Antenna types not included in this list, having a gain greater
than the maximum gain indicated for that type, are strictly prohibited for use with this device.
3448-238 C
Page 2–1
Chapter 2
Safety
Safety

Publicidad

loading