VOLTWERK SmartConnect 8 Instrucciones De Servicio página 119

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

6 Installing the power supply (optional)
NOTICE
42
1. Fit the power supply unit (3) onto the top-hat rail (1) adjacent to the
CAN distributor (2). Please note that:
The power supply must sit securely on the top-hat rail.
|
The power supply must not be loose in the SmartConnect.
|
2. Plug the 4-pin plug of the connection cable into the power supply unit.
(4) Mounting rail bus connector
(5) CAN distributor
3. Plug the 5-pin connector of the connection cable onto the mounting rail
bus connector (4) on the CAN distributor (5).
Material damage due to damaged cables
If damaged, the strands may break and overheat.
Do not cut or damage the strands when stripping the insulation.
|
4. Strip and remove the insulation from the mains cable.
5. Put cable end sleeves on the wires.
6. Loosen the connection screws of the screw terminals on the power
supply (see Fig. 3.6, page 21, item (3)).
Screw terminals
Use
Power supply
Earthing (auxiliary power supply)
N conductor (auxiliary power supply)
L conductor (auxiliary power supply)
7. Insert the ends of the wires into the screw terminals.
8. Tighten the connection screws (tightening torque 0.5 Nm).
9. Check the screw terminals hold the wires firmly.
(4)
(5)
SmartConnect
Operating manual

Publicidad

Tabla de contenido
loading

Productos relacionados para VOLTWERK SmartConnect 8

Tabla de contenido