Descargar Imprimir esta página

SKYLOTEC SKYVEST Instrucciones De Uso página 16

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

continuous green light indicates that the battery is fully charged. If you
disconnect the control module from the charging cable, the system swit-
ches off.
Step 2
Plug in the inflator
and then into the release unit so that this is possible without too much
resistance (otherwise the position will not be correct). It is best to insert
the inflator through the flex band first. Secure the inflator by inserting the
locking pin fully. Close the zip on the bag.
Plug in the inflator
Step 3
Fitting the SKYVEST
Put on the SKYVEST. Adjust all straps and straps to your body size so that
you have a finger's width of space between your body and the fastening
loops. After all, the system is only useful if it stays on your body in an
emergency!
16
MAT-BA-0229-03_20240305.indd 16
MAT-BA-0229-03_20240305.indd 16
Please ensure that the SKYVEST system is kept at a steady char-
ge. The red flashing light indicates that the battery is charging. A
Check that the control module is clean
before plugging it in. Make sure that
the locking pin is pulled out. Remove
the black protective cap on the inflator.
Insert the inflator through the flex band
Push in the safety pin and
place the flex strap and gas
cylinder.
26.03.2024 11:09:26
26.03.2024 11:09:26

Publicidad

loading

Este manual también es adecuado para:

Opus 2.0