Publicidad
Idiomas disponibles
Idiomas disponibles
• Regularly check the condition of the vest, zips and buckles.
• Check that the inflator that you insert into the release unit is not dirty and
that the electronics can run through the complete system check (green
flashing light after switching on).
• Airbags visually, for abrasion and damage as well as tears and cuts
• Fastening loops, zip fasteners and seams of the vest
• Check all waist and chest strap buckles for tears and deformation.
If you are unable to check the SKYVEST, please send it to your local
dealer or directly to Skylotec GmbH.
12.) ERROR DESCRIPTION
The LED flashes red-green.
The LED lights up red-green
even though I have charged
the system for at least 3
24
MAT-BA-0229-03_20240305.indd 24
MAT-BA-0229-03_20240305.indd 24
Error description
hours
Fault diagnosis
Charge the control module. A red-
green flashing light is a warning sig-
nal. The device is still active, but you
only have a limited application time
left. Take the system to be charged.
Check the charging process. If the
LED is still flashing red-green after a
charging time of at least 3 hours, the
system needs to be checked.
The system no longer works for 8
hours, the system was probably
not properly connected to the pow-
er supply. The system should flash
red during charging. Try charging
the system again or the battery has
reached the end of its service life and
a service is required
26.03.2024 11:10:01
26.03.2024 11:10:01
Publicidad
