SKYLOTEC SKYVEST Instrucciones De Uso página 25

No LED flashes, the device
cannot be switched on
The LED is permanently
green, but the device is no
longer plugged in. The de-
vice cannot be switched on
or off, it does not respond
I do not bring the inflator into
13.) CUSTOMER SERVICE
After every 12 months, a general service by the manufacturer or an expert
is mandatory. The SKYVEST can also be sent to the manufacturer or
the dealer responsible in your region. The service by Skylotec GmbH is
MAT-BA-0229-03_20240305.indd 25 MAT-BA-0229-03_20240305.indd 25
The LED lights up
permanently red.
the release unit
The system is not ready for operati-
on. Switch the system off and then
on again, wait a few seconds. If
the system is still permanently red,
switch it off and remove the inflator.
Check whether the inflator has alrea-
dy been used. Insert a new inflator.
Make sure that it is inserted correctly
and that the locking pin is closed.
Then switch the system on again.
If the LED still lights up red, charge
the system. If the system still lights
up red after switching on again, then
the system is due for a service.
Charge the device with a USB cable.
If the device cannot be charged, the
system must be switched off for che-
cking.
The inflator must be inserted with
slight resistance. Make sure that the
contacts fit into the contact holes.
Switch off the system. Switch the
system on. Then remove the inflator
again. The system should now be re-
charged for at least 15 minutes
The inflator must be inserted with
slight resistance. Make sure that the
contacts fit into the contact holes.
Make sure that you have pulled out
the locking pin completely before
inserting it. If you have any queries,
please contact the manufacturer or
the service centre - Never force the
inflator into place
25
26.03.2024 11:10:01 26.03.2024 11:10:01