Publicidad
Signal (LED)
Red LED on
First Phase (Constant Current Mode).
Orange LED on
Second Phase (Constant Voltage Mode).
Third Phase (Constant Voltage Mode) Charge Complete.
Green LED on
However, after full re-charge, leaving the charger connected moves to float-
charge mode to help to maintain a healthy balance between batteries.
Cooling Fan Locked > 1 flash between pause.
Over Voltage Protection / Output Short Circuit / Battery Reverse Polarity
> 2 flashes between pause.
Over Temperature Protection > 3 flashes between pause.
Charge Time has exceeded 16 hrs during phase 1 or 2 > 4 flashes between pause.
Red LED
flashing
Pre-charge Timeout
followed by
Pause
CC Timeout
CV Timeout
Battery Disconnection
O
Note:
Note: Re-charge the machine fully after its last use. Do not leave the machine in a discharged state.
Under abnormal use;
i.e. leaving the machine without charging for a period of time, we advise that you follow
these steps:
Float charge mode allows to maintenance LFP batteries at the right level of health.
The machine should be left on float charge overnight or over the weekend at least once per month.
Charge fully the day before you start using the machine again.
DE
Schaltbild
FR
Schéma
NL
Principeschema
PT
Diagrama esquemático
IT
Schema apparecchio
ES
Diagrama esquemático
PL
Schemat
SE
Schematiskt diagram
FI
Kytkentäkaavio
DA
Skematisk diagram
Charging Light Sequence
GB
Meaning
Condition
RED LED
Flashing 4
Times
means illuminates continuously
CNTR
YELLOW LED
GREEN LED
O
O
O
O
Schematic Diagram
MOTOR DRIVE
CHARGER
TRACTION
CONTROL
95
VAC MOTOR
BRUSH MOTOR
LIGHT
PUMP
DC BATTERY
TRACTION MOTOR
HORN
Publicidad
