Klarstein HAVASIA UV 6 Manual página 43

Note: The salt container must only be refilled when the indicator light comes
on. Depending on how well the salt dissolves, the indicator may light up, even
though there is salt in the container. If salt stains remain after rinsing, run a
quick or soak programme to remove the excess salt.
Setting the salt quantity
The dishwasher is designed so that the amount of salt can be adjusted according
to the hardness of the water being used. This is to optimise and individually adjust
salt consumption. To adjust the salt consumption, please proceed as follows.
1 Close the door and switch on the appliance.
2 Within 60 seconds after switching on the appliance, press and hold the
programme button for more than 5 seconds to start the water softener
setting mode.
3 Press the programme button again to select the correct setting according to
local conditions; the setting changes in the following order: H1 > H2 > H3 >H4
> H5 > H6.
4 If you do not press any button within five seconds or if you press the power
button to exit the setting mode, the setting will be saved by the programme.
Water hardness
°dH °fH
1) 3
0 - 5 0 - 9
6 - 11 10 - 20
12 - 17 21 - 30
18 - 22 31 - 40
23 - 34 41 - 60
35 - 55 61 - 98
¹ German hardness level
² French hardness level
³ British hardness level
International hardness level
4
Default factory setting is hardness level H4
5
Each cycle with a regeneration process consumes an additional 2.0 litres of
6
water, the energy consumption increases by 0.02 kWh and the programme
duration is extended by 4 minutes.
mmol/l
4
°Clark
3
0 - 6 0 - 0.94
7 - 14 1.0 - 2.0
15 - 21 2.1 - 3.0
22 - 28 3.1 - 4.0
29 - 42 4.1 - 6.0
43 - 69 6.1 - 9.8
Regeneration
6
(takes place
Hardness
after every Xth
level
5
programme
sequence)
H1 no regeneration
H2 10
H3
H4
H5
H6
Salt
consumption
(gram/cycle)
0
9
5 12
3 20
2 30
1 60
EN
43