Klarstein HAVASIA UV 6 Manual página 50

EN
50
ENERGY SAVING RECOMMENDATIONS
• The eco programme is suitable to clean normally soiled tableware, that for
this use, it is the most efficient programme in terms of its combined energy
and water consumption, and that it is used to assess compliance with the EU
ecodesign legislation.
• Loading the household dishwasher up to the capacity indicated by the
manufacturer will contribute to energy and water.
• Incorrect loading can have these consequences:
- a deteriorated cleaning result
- damage to property due to the blocking of the spraying arms.
• Manual pre-rinsing of tableware items leads to increased water and energy
consumption and is not recommended.
• Washing tableware in a household dishwasher usually consumes less energy
and water in the use phase than hand dishwashing when the household
dishwasher is used according to the manufacturer's instructions.
• The values given for programmes other than the eco programme are
indicative only.
OPERATION
Starting a programme
1 Pull out the lower and upper baskets, load the dishes and push them back in.
It is recommended to load the lower basket first and then the upper basket.
2 Fill in the detergent.
3 Plug the power plug into the mains socket.
4 Make sure that the water supply is set to full pressure.
5 Close the door and press the On/off button to switch on the machine.
6 Select a programme, the corresponding symbol lights up. Then press the
start/pause button and the dishwasher will start the programme.
Changing the programme while the dishwasher is running
A programme can only be changed if it has only been running for a short time,
otherwise the detergent has already been released or the rinse water has been
drained with detergent. In this case, the dishwasher must be reset and the
dispenser refilled. To reset the dishwasher, proceed as follows:
1 Press the start/pause button to pause the rinsing process.
2 Press the programme button for more than 3 seconds to put the machine in
programme selection mode.
3 Press the programme button again to select the desired programme.
4 Press the start/pause button. After 1 second, the dishwasher starts.