oventrop HydroControl D Instrucciones De Uso página 36

HydroControl D
Accessories and spare parts
3.5 Technical data
General information
Max. operating
temperature ts
Min. operating
temperature ts
Max. operating
pressure ps
Fluid
Material
Diaphragm housing
Body
Seal
Handwheel
4. Accessories and spare parts
Designation
Adapter
Wire seal kit
Insulation shells
5. Transport and storage
Transport the product in its original packaging.
Store the product under the following conditions:
Temperature range
Relative air
humidity
Particles
Mechanical
infl uences
36
120 °C
-20 °C
25 bar (PN 25)
Heating and cooling water
according to VDI 2035 or
ÖNORM 5195
Water-glycol mixtures with
max. 50 % glycol content
Brass
Dezincifi cation resistant brass
EPDM
Plastic
Item no.
1069601
1089091
Nominal Item no.
size
DN 15 1069620
DN 20 1069621
DN 25 1069622
DN 32 1069623
DN40 1069624
DN50 1069625
-20 °C to +55 °C
max. 95 % non-condensing
Store in a dry and dust-protected
place
Protected from mechanical shock
Protected from UV rays and
Radiation
direct sunlight
Do not store together with
Chemical
solvents, chemicals, acids, fuels or
infl uences
similar substances
6. Mounting
WARNING
Risk of injury from pressurised components!
Media escaping under pressure can cause injuries.
!
Only carry out installation work when the
system is depressurised.
!
For retrofi tting an existing system: Drain the
system or shut off the supply pipes of the
system section and depressurise the system
section.
!
Wear safety goggles.
CAUTION
Risk of injury on hot or cold components and
surfaces!
!
Wear suitable protective clothing to avoid
unprotected contact with hot or cold fi ttings
and system components.
!
If necessary, wait until the component
has reached approximately the ambient
temperature before starting work.
NOTICE
Damage to property due to lubricants!
Seals can be destroyed by the use of greases or oils.
!
Do not use greases or oils during mounting.
!
If necessary, fl ush dirt particles and grease and
oil residues out of the pipework.
!
When selecting the operating medium, observe
the current state of the art.
!
If the operating medium is contaminated, install
a strainer in the supply pipe.
1000100590_10239176 000 00