Publicidad
Attaching and detaching the
nozzle
Attaching the nozzle,
► Slide the nozzle into the telescoping
wand.
► Rotate the nozzle until it engages.
► If the nozzle does not slide easily into
the telescopic lance: Lubricate the
gasket on the nozzle with grease for
fittings.
Detaching the nozzle,
► Press nozzle and telescoping wand
together and turn to the limit stop.
► Pull the nozzle and telescoping wand
apart.
Fitting and adjusting the carry‐
ing system
Fitting the carrying system,
► Put on the carrying system.
► Close the buckle of the chest strap.
Adjusting the carrying system,
► Adjust the carrying system so that the
buckle rests about the width of one
hand above your hip.
► Tighten the chest strap until the chest
strap fits closely to your upper body.
Adjusting the shaft length
The shaft can be adjusted to different
lengths to suit the user's application.
Unroll the high-pressure hose,
► Completely unroll the high-pressure
hose.
Adjust the shaft length,
► Maintain an angle of no more than
45° to the horizontal.
► Release the quick release clamp.
► Adjust the shaft to the required
length.
► Close the quick release clamp.
► Make sure that the shaft cannot be
pushed in or pulled out and that the
16
C:
C:
D:
D:
E:
F:
quick release clamp is closed up to
the limit stop.
The shaft is properly adjusted if it cannot
be pushed in or pulled out and the quick
release clamp is closed up to the stop.
Securing the high-pressure hose:
► Wind up the excess high-pressure
hose evenly over the reel.
► Secure the high-pressure hose in
position with the hook and loop fas‐
tener.
Holding and guiding the tele‐
scoping wand
► Connect the buckle of the chest strap
to the buckle of the carrying system.
► Hold the telescoping wand firmly with
one hand on the handle so that your
thumb wraps around the handle.
► Hold the telescoping wand firmly with
your other hand on the handle hose
so that your thumb wraps around the
handle hose.
Operation
Adjust the angle,
► Pull out the securing pin and hold it
tight.
► Set the nozzle to the required angle.
► Release the locking pin.
The locking pin must engage audibly.
► Make sure the nozzle cannot be
pushed in or pulled out any more and
that the locking pin has engaged.
Press the trigger of the spray gun,
► Press the retaining latch down.
► Depress the trigger and keep it
pressed.
The high-pressure pump starts up
automatically and water flows out of
the nozzle.
Lock the trigger of the spray gun,
► Release the trigger.
0457-367-0065-A. VA0.E23.
G:
I:
H:
Publicidad
