Publicidad
Idiomas disponibles
Idiomas disponibles
Product description
CAUTION! Risk of injury due to non-des-
ignated use! If wood or other substances em-
bedded with foreign bodies are sawn with the
chain saw, injury can result.
■
Only use the chain saw for light wood sawing
work.
■
Before sawing wood, check for foreign bod-
ies, e.g. nails, screws, fittings.
2.2
Possible foreseeable misuse
■
Do not saw off branches that are directly
above or at an oblique angle above the user
or other persons.
■
Do not use old oil to lubricate the saw chain.
■
In order to protect the environment, mineral
saw chain oil should not be used.
Note: Find out whether mineral saw chain oil
is prohibited in your country!
■
Do not use the appliance in a potentially ex-
plosive atmosphere.
2.3
Residual risks
Even when using the appliance as intended,
there is always a certain residual risk that cannot
be excluded. The following hazards cannot be
ruled out due to the nature and design of the de-
vice.
■
Contact with the exposed teeth of the chain
(risk of cutting).
■
Access to the moving chain (risk of cutting).
■
Sudden and unforeseen movement of the
chain bar with saw chain (risk of cutting).
■
Separation of parts of the chain (e.g. risk of
cutting/injury).
■
Separation of parts of the wood being worked
on.
■
Impairment of hearing during work if ear de-
fenders are not used.
2.4
Safety and protective devices
WARNING! Danger of serious injury from
manipulated safety and protective devices. As
a result of manipulated safety and protective de-
vices, serious injury can occur when working with
the chain saw.
■
Never deactivate safety and protective devic-
es!
■
Only work with the chain saw if all safety and
protective devices function correctly.
443698_a
2.4.1
Switch-on protection
If the operator applies the throttle quickly several
times in succession, the chain saw switches off
for a few seconds to protect the electronics and
the saw chain. In this case, wait until the chain
saw can be switched on again.
2.4.2
Chain brake/chain brake bracket
The chain saw has a manual chain brake that is
triggered by the chain brake bracket, for example
if kickback occurs. If the chain brake is tripped,
saw chain and motor are stopped immediately.
2.4.3
Overload protection
The chain saw is equipped with an overload pro-
tection which switches off in case of overload.
After a cooling-down phase, the chain saw can
be switched on again.
2.5
Symbols on the appliance
2.5.1
Safety signs
Symbol
Bedeutung
Wear protective gloves!
Wear sturdy shoes!
Read the operation instructions be-
fore starting operation!
Always operate the chain saw with
both hands!
Pay special attention when handling
this appliance!
Danger of kickback! Never saw with
the tip of the chain bar!
Do not operate the chain saw with
one hand!
33
Publicidad
