Help in case of malfunction
8.4
Chain maintenance table
Chain saw
Article
numbers
CS 3635
127736,
127737
CS 3635
127201,
127489
CS 3640
127750,
127749
CS 3640
127546,
127490
8.5
Cleaning the air filter (26)
To protect the inside of the appliance from soil-
ing, the air intake area for the motor cooling sys-
tem is fitted with an air filter. If the dust load is
low, brushing from the outside is sufficient. If the
dust load is high:
1. Remove screw (26/1).
2. Remove filter cover (26/2).
3. Remove the filter (26/3).
4. Clean the filter (tap on a firm surface or blow
out).
5. Install the filter again.
6. Secure the filter cover with the screw again.
443698_a
Saw chain,
File diameter
chain bar
90PX052X,
4.5 mm
144MLEA041
91P052X,
4.0 mm
140SDEA041
90PX056X,
4.5 mm
164MLEA041
91P056X,
4.0 mm
160SDEA041
Depth gauge
WARNING! Danger of serious injury. Use
of an unapproved saw chain or guide rail on the
chain saw can result in serious injuries.
■
Use only approved saw chains and guide rails.
Top plate
Down angle
angle
Turn an-
Tilt angle of
gle of the
the tool
tool
30°
0°
30°
0°
30°
0°
30°
0°
9 HELP IN CASE OF MALFUNCTION
CAUTION! Risk of injury. Sharp-edged
and moving appliance parts can lead to injury.
■
Always wear protective gloves during mainte-
nance, care and cleaning work.
■
Switch off the appliance and remove the re-
chargeable battery.
NOTE For malfunctions that are not listed in
this table or that you cannot resolve yourself,
please contact our customer service.
Head tilt angle
Depth
(55°)
gauge
Side angle
75°
0.64 mm
80°
0.64 mm
75°
0.64 mm
80°
0.64 mm
File
47