Publicidad
Idiomas disponibles
Idiomas disponibles
Safety instructions
No.
Component/display
2
LED for chain brake (green/red):
■
Flashes green: Chain saw is in
WAIT mode. The release lever
(02/12) must be pressed within 5 s
to switch on the chain saw.
■
Lights up green: Release lever is
pressed. Chain saw is ready for
operation.
■
Lights up red: Chain brake is acti-
vated.
■
Flashes red:
■
The overload protection device
has switched off the chain
saw, or
■
overheating of the chain saw
or battery
3
LED for oil level (red): Lights up when
the oil level is low. Top up with saw
chain oil!
4
LED for ECO mode (green): Lights up
when ECO mode is activated.
2.7
Scope of supply (04)
NOTE The rechargeable battery and the
charging unit are not included.
After unpacking, check that all the components
have been delivered.
No.
Component
1
Battery chain saw
2
Chain bar
3
Saw chain
4
Protective cover of the chain bar
5
Operating instructions
2.8
Optional accessories
The following products can be purchased sepa-
rately:
Product
AL-KO battery belt BBA 40
solo by AL-KO battery belt
BB40 with battery adapter
443698_a
Saw chains and chain bars, see chapter 8.4
"Chain maintenance table", page 47.
3 SAFETY INSTRUCTIONS
3.1
structions, illustrations and specifications
provided with this machine. Failure to follow all
instructions listed below may result in electric
shock, fire and/or serious injury.
■
The term "machine" in the warnings refers to your
mains-operated (corded) machine or battery-op-
erated (cordless) machine.
3.1.1
■
■
■
3.1.2
■
■
■
■
Item No.
113786
127573 +
127579
■
General electrical machine safety
warnings
WARNING! Read all safety warnings, in-
Save all warnings and instructions for fu-
ture reference.
Work area safety
Keep work area clean and well lit. Clut-
tered or dark areas invite accidents.
Do not operate machines in explosive at-
mospheres, such as in the presence of
flammable liquids, gases or dust. Ma-
chines create sparks which may ignite the
dust or fumes.
Keep children and bystanders away while
operating a machine. Distractions can
cause you to lose control.
Electrical safety
Machine plugs must match the outlet.
Never modify the plug in any way. Do not
use any adapter plugs with earthed
(grounded) machines. Unmodified plugs
and matching outlets will reduce risk of elec-
tric shock.
Avoid body contact with earthed or
grounded surfaces, such as pipes, radia-
tors, ranges and refrigerators. There is an
increased risk of electric shock if your body is
earthed or grounded.
Do not expose machines to rain or wet
conditions. Water entering a machine will in-
crease the risk of electric shock.
Do not abuse the cord. Never use the cord
for carrying, pulling or unplugging the
machine. Keep cord away from heat, oil,
sharp edges or moving parts. Damaged or
entangled cords increase the risk of electric
shock.
When operating a machine outdoors, use
an extension cord suitable for outdoor
35
Publicidad
