BH FITNESS Tecnovita YV12 Instrucciones De Montaje Y Utilización página 12

Thank you for purchasing our product.
While we do our best to ensure the
quality of all our products, occasional
errors or omissions may occur. If you
notice a defect or missing parts,
contact the distributor of the product.
Read through the whole manual
before using this machine.
GENERAL INSTRUCTIONS.-
Before plugging the unit in, make sure
that the mains supply voltage matches
that stated
characteristics label.
Check that the pin layout on the plug is
suitable for the electric socket. If this is
not the case, please consult your
supplier.
Do not use an adaptor with this
appliance.
Always follow these recommendations
when using electrical appliances:
1. Do not allow children or the disabled
to use the appliance without strict
supervision from a qualified person.
2. Never use
recommended by the manufacturer.
3 Do not use the machine if the mains
cable becomes damaged or worn.
4 Keep the mains cable away from hot
on the machine's
accessories
English
surfaces.
5 Do not use the machine outdoors.
6 To unplug the machine, first put the
switch to the «0» position and then
unplug it from the wall socket.
7 This unit has been designed for
home use only.
8 The Vibro Balance vibration platform
is designed for a maximum user weight
of 120 kg.
9 Keep your hands well away from any
of the moving parts.
10 Use suitable clothing and footwear.
Make sure that all laces/cords are tied
correctly.
11 It is not advisable to keep your unit
in damp locations for long periods as it
will be prone to rust.
SAFETY BREAKER.-
This model is equipped with an
electronic circuit breaker to protect both
the electronic and electrical circuits.
This safety device (fuse) will be
automatically triggered if the unit is
subjected to abnormal force or heat.
1.- Set switch (L), located on the
casing, to the "0" (OFF) position Fig.B.
2.- Change the fuse (C) (5 Amp).
3.- Next, set switch (L) to the "I" (ON)
position and the unit will be ready for
use again.
Plug the unit into a wall socket with an
EARTH terminal. Set switch (L) to
Position [1].
not
12