Cleco mPro300GCD-STO Serie Descripción Del Hardware página 13

- Voltages > 2.4 V are interpreted as a one.
Open inputs are preset to zero using a pulldown
-
resistor.
The power supply pins are connected directly to the
•
main board power supply.
Note
Data loss
If the connection is interrupted during opera-
tion, a system reset may result.
► Do not plug or unplug consumers during
operation.
Pin RS232-1 9 Pin D-Sub, pin, with screw lock
1 –
2 RxD
3 TxD
4 –
5 GND
6 –
7 RTS
8 CTS
9 –
X7 – Anybus Compact Com
Order No. Module
544357PT PROFINET M40 RJ45
962291PT PROFIBUS M40 M12
962292PT PROFIBUS M40 DB9
962293PT DeviceNet M40
962294PT PROFINET M40 M12
962297PT Ethernet/IP M40 RJ45 2 port
962299PT Modbus/TCP M40 RJ45 2 port
Use only M40 modules. M30 modules are not
supported.
Installation Instructions for Fieldbus Module
Push the module in as far as it will go, then
press it slightly to the right and push it in com-
pletely. The nose on the module must not rest
on the circuit board.
X9, X10 – Input/Output
Digital I/O Interface
The required signal circuits are connected to these in-
put/output connectors. The signal groups are connected to
the power supply.
Apex Tool Group
8 inputs/8 outputs, optically isolated for 24 V level.
•
• Output current: 500 mA per output, 1,000 mA total.
Signal X9
Pin I/O
12
11
10 Output
9 Output
8 Output
7 Output
6 Input
5 Input
4 Input
3 Input
2
1
Internal power supply (example)
Fig. 1-1: Phoenix Mini Combicon MCD 1,5/12-G1F-3,81
Inputs
Internal 24 V power supply for the controller.
•
Pin 11 and 23 (common GND) serve as a "return
•
line"for the outputs.
• Pin 11 and 23 must be connected to Pin 12 or 24
withjumpers.
Outputs
• Internal 24 V power supply for the controller.
• Pin 2 and 14 (common output) are the voltage
sourcefor the inputs.
• Pin 2 and 14 must be connected to Pin 1 or 13.
P2552HW | REV D l 2023-12
Note
Overload shutdown
The current monitor switches off the output in
the event of an overcurrent.
► A single device must not require a cur-
rent of more than 500 mA.
Signal X10
Descrip- Pin
tion
Supply 24
GND Int.
Supply 23
GND I/O
O3 22 Output
O2 21 Output
O1 20 Output
O0 19 Output
I3 18 Input
I2 17 Input
I1 16 Input
I0 15 Input
Supply 14
+24 V Ext
.
Supply 13
+24 V Int.
1
EN
I/O Descrip-
tion
Supply
GND Int.
Supply
GND I/O
O7
O6
O5
O4
I7
I6
I5
I4
Supply
+24 V Ext
.
Supply
+24 V Int.
13