Parameter Adjustment - Extended Adjustment - Balluff BMD 1L-K Serie Manual De Instrucciones

7 Set up with the display and adjustment module
Switch-on phase
Measured value indica-
tion
Main menu
34
After switching on, the BMD 1L carries out a short self-test where the
device software is checked.
The output signal transmits a fault signal during the switch-on phase.
The following information is displayed on the display and adjustment
module during the startup procedure:
•
Instrument type
•
Device name
•
Software version (SW-Ver)
•
With the [->]
modes.
digits.
In the second view, the selected measured value and a correspond-
ing bar graph presentation are displayed.
In the third view, the selected measured value as well as a second
selectable value, e.g. the temperature, are displayed.
7.3

Parameter adjustment - Extended adjustment

For technically demanding measuring points, you can carry out
extended settings in "Extended adjustment".
tions:
Setup: Settings, e.g. measurement loop name, medium, vessel,
adjustment, signal output, device unit, false signal suppression,
linearization curve
Display: Settings, e.g., for language, measured value display, lighting
Diagnosis: Information, e.g. on instrument status, pointer, measure-
ment certainty, simulation, echo curve
Additional adjustments: Reset, date/time, reset, copy function
Info: Instrument name, hardware and software version, date of manu-
facture, instrument features
-