QJMOTOR SRT 700 Manual Del Usuario página 38

Air filter maintenance
The air filter should be maintained regularly, espe-
cially if you drive in a dusty or sandy area.
• Remove the seat cushion1,
the vehicle front left and right
guards 2, the left and right
bumpers 3 and the left and
right side guards 4 respec-
tively, and then remove the
fuel tank to see the air filter
5.
• Remove the eight air filter cover fixing screws 6,
and remove the air filter cover.
• Remove the air filter element 7.
• Soak the air filter element in clean gear oil until it
is saturated, then squeeze out the excess oil.
• Reinstall the parts in the reverse order of disas-
sembly.
Caution
Gasoline and low flash point solvents are highly
flammable substances and cannot be used to
clean the filter element.
Coolant
Recommended coolant type: FD-2
When the new car leaves the
factory, the coolant has been
installed. During maintenance,
pay attention to the inspection
of the coolant level in the
expansion kettle.
When the coolant becomes
cloudy or it is time for mainte-
nance, please replace the cool-
ant in time.
The filling port 1 for the coolant in the radiator
water tank is located in the front right side fender of
the vehicle.
Open the coolant filler cap and fill in an appropriate
amount of coolant.
After adding the coolant, reinstall the radiator
filler cap.
Start checking the
expansion kettle cool-
ant when the engine
is off and cool. When
checking, make sure
the motorcycle is on a
33