Descargar Imprimir esta página

3M PELTOR ComTac VIII Headset Manual Del Usuario página 14

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 57
12.2. TO REMOVE AND REPLACE THE HYGIENE
KIT
1. Hold the inner edge of the ear cushion and pull it straight
out.
2. Remove the old ear cushion.
3. Remove the foam liner.
4. Put the new foam liner into the earcup.
5. Align the new ear cushion with the earcup.
6. Push the ear cushion into place.
CAUTION: Make sure that the cushion cover is not pinched
between the earcup and the ear cushion.
13. SPARE PARTS AND ACCESSORIES
Article number
M194/2
Wind shield kit for environmental mic
1086 SV/1
Battery compartment cover
AGM/1
Headband ComTac™ VIII Headset
A47/1
Microphone guide
MT71/1
Boom microphone dynamic
P3ADG47-F SV/2
ARC rail attachment, 1 pair
HY68
Hygiene kit
HY80-EU
Hygiene kit with gel ring
M171/2
Wind protector for microphone, 2 pcs
Hygiene tape for boom microphone,
HYM1000
black
14. STORAGE
• Store the product in a clean and dry area before and after
use.
• Always store the product in the original packaging and
away from any sources of direct heat or sunlight, dust
and damaging chemicals.
• Storage temperature range: –20°C (–4°F) to 40°C (104°F).
Storage temperature range up to 72 hours: -55°C (-67°F) to
71°C (160°F).
When storing above 50°C (122°F), foam rings must be
removed.
• Relative humidity: <90%.
• Headband versions:
Make sure that no force is applied to the headband and
that the cushions are not compressed.
NOTE: Remove the batteries when storing the product for
long periods of time.
EN
Name
9

Publicidad

loading

Este manual también es adecuado para:

Mt14h418a-02 geMt14h418a-02 gn