AQUA SPHERE VSP100 Manual De Instrucciones página 13

Default Schedule
SPEED 1 duration =2 hours 3000 RPM
SPEED 2 duration =10 hours 1500 RPM
SPEED 3 duration =2 hours 2500 RPM
SPEED 4 duration =4 hours 1000 RPM
Press Start/Stop button and LED is on for pump to run.
SPEED 1 is set to begin at 8:00am and run at 3000 RPM for 2 hours. When SPEED 1 is complete
the pump immediately begins running the default SPEED 2. SPEED 2 is factory default to 1500
RPM and will last for 10 hours. When SPEED 2 has completed its run the pump will run SPEED
3 at 2500 RPM for a duration of two hours. When SPEED 3 has completed its run the pump will
run SPEED 4 at 1000 RPM for a duration of four hours.
After 18 hours of run time and completing its run of SPEED 4, the pump will enter a paused
state for the next 6 hours. The pump will restart at 8:00am every morning and go over the
default schedule again. Except for default schedule, custom schedule is also available.
Custom Schedule and Quick Clean
To customize the run schedule for your Variable Speed Pump, the pump must be stopped. Be
sure that the Start/Stop button LED is not illuminated.
Programming a Custom Schedule:
When programming, the LED light next to the parameter ("Speed", "Time" and "Duration")
you are setting will blink.
1. Stop the pump if it is running by pressing the Start/Stop button.
2. Press the "1" button. The LED above the selected SPEED will begin to blink and the "Speed"
parameter LED will blink while editing. See Figure 1.
3. Use the "+" and "-" arrows to adjust the speed in RPM for SPEED 1.
Speed is adjusted up or down by increments of 10 RPM.
4. Press the "1" button again and the display will change to SPEED 1 start time. The "Time"
parameter LED will begin to blink. See Figure 2.
5. Use the "+" and "-" arrows to adjust the daily start time for SPEED 1.
6. Press the "1" button again and the display will change to SPEED 1 duration. The "Duration"
parameter LED will begin to blink. See Figure 3.
7. Use the "+" and "-" arrows to adjust the duration for SPEED 1 in hours and minutes.
The duration parameter is adjusted in 1 minute increments.
8. Pressing the "1" button will continue to cycle through these parameters, but the changes
are immediately saved as they are adjusted.
9. Press the "2" button. The LED above SPEED 2 will begin to flash and the corresponding pa-
rameter LED will flash while editing.
10. Use the "+" and "-" arrows to adjust the speed in RPM for SPEED 2.
11. Press the "2" button again and the display will change to SPEED 2 duration.
SPEED 2 and 3 do not have a start time, as they begin their duration immediately after the
previous SPEED finishes.
12. Use the "+" and "-" arrows to adjust the duration for SPEED 2 in hours and minutes.
13. Repeat steps 9-12 to program SPEED 3-4, same procedures for QUICK CLEAN.
13