Publicidad
Idiomas disponibles
Idiomas disponibles
Electrical Requirements
FOR YOUR SAFETY
This Pump must be installed by a qualified pool professional or licensed or certified
electrician and must conform to National wiring rules and any local codes. Before installing
this product, read and follow all warning notices and instructions that accompany this prod-
uct. Failure to follow warning notices and instructions can result in property damage, personal
injury, or death.
Turn OFF the power supply before installing or servicing pump.
Before installing the pump, open the carton and check the pump for concealed damage, for
example, dents , a broken base, cracks etc. If any damage is found, please contact the original
purchasing shop.
Plumbing Installation
• Protect the pump against direct sunlight and excessive moisture (sun and run etc.)
• Locate pump on a solid surface as close to the pool/spa as possible. For trouble free self-priming,
consult local regulations for minimum distances between pool and pump.
• Leave enough space for maintenance and service.
• To reduce friction loss, use direct and short piping to the suction.
• Ensure the surface drainage is adequate for prevent flooding.
• The pump suction inlet height should be as close to the water source as possible, do not
exceed 1,5m.
• Avoid using a suction pipe smaller than pump connection. Suction pipe should be same or
larger than discharge pipe.
• Prevent the motor from overheating. Ensure that the pump is properly ventilated.
Wiring
Note: Use this pump ONLY for home voltage 220-240Vac, single phase input power. Connec-
tion to the wrong voltage, or use in other application may cause damage to equipment or
personal injury.
RISK OF ELECTRIC SHOCK
• The pump shall be installed follow the National wiring rules and any local code.
• Make sure connect to correct voltage 220-240Vac.
• All electrical connections are tight and clean.
• Before wiring the pump, make sure that all circuit breakers and switches are turned off. After
disconnecting the power to the pump, be sure to wait six (6) minutes before turning on or
servicing the drive.
Bonding and Grounding
The pump must be installed in accordance with the National wiring rules and any local codes.
Connect the electrical service ground using the green ground terminal. To reduce the risk of a
current, the pump motor must be bonded to all metal parts of the swimming pool. Use a solid
copper bonding conductor.
9
Publicidad
