IMPORTANT SAFETY INSTRUCTIONS
WARNINGS:
• This manual can be read and downloaded as a PDF file from the website: www.aq-
uaspheremanuals.com
• The appliance described in this manual is specially designed for the pre-filtering and
recirculation of water in swimming pools, with clean water at temperatures that do
not exceed 35ºC
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety. Children should be supervised to ensure that they
do not play with the appliance.
• This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience and knowl-
edge if they have been given supervision or instruction concerning use of the appli-
ance in a safe way and understand the hazards involved. Children must not play with
this appliance. Cleaning and maintenance must not be carried out by children without
supervision.
• Our pumps may only be assembled and installed in pools compliant with standards
IEC/HD
60364-7-702 and required national rules. The installation should follow standard IEC/
HD 60364-7-702 and required national rules for swimming pools. Consult your local
dealer for more information.
• If a self-priming pump is to be fitted above the water level, the pressure differential
to the pump suction pipe should not be higher than 0.015 MPa (1.5 mH2O). Ensure
that the suction pipe is as short as possible as a longer pipe would increase suction
time and the installation's load losses.
• The pump is intended to be used while fastened to a support or while secured in a
specific location in a horizontal position.
• Place a sump with an adequate outlet for the liquid where flooding is likely to occur.
• The pump cannot be installed in Zone 0 (Z0) or Zone 1 (Z1). To see drawings, refer to
page 7/8.
• See the maximum total head (H max), in meters. See page 6.
• A disconnector must be fitted to the fixed electrical installation in accordance to the
installation regulations.
• Failure to heed the warnings can cause serious damage to the pool's equipment or
serious injury, including death.
• Observe the regulations in force on accident prevention.
• If the unit breaks down, do not try to repair it yourself. Contact a qualified service
engineer instead.
• All modifications to the pump require the manufacturer's prior authorization. Spare
parts and original accessories authorized by the manufacturer ensure greater safety.
The pump's manufacturer may not be held liable for any damage caused by unauthor-
ized spare parts or accessories.
• Do not dry-run the pump or without water (the warranty will become null and void).
4