S&P HV-STYLVENT Serie Manual De Instrucciones página 11

rod sticking out from the support plate (f).
Fig.17.- Fix the support plate (f) to the wall and tighten bolts (d).
Fig.18.- Depending on the position of the incoming electrical cables, make a hole on the gland (i) on the
front cover (a) or in the gland (p) on
(j) and connect to the terminal box (k).
Fig.19.- Mount the internal cover (a) by slotting the rectangular openings (1) on the top of the cover (a) into
the receivers (m) of the support plate (f) until the two knobs (c) are correctly positioned.
Fig. 9.- Tighten the locking screw (b).
Electrical wiring
- Before proceeding to the electrical wiring, make sure it is disconnected from the electrical supply. Also make
sure that the impeller rotates freely and there are no obstructions in the inlet or outlet fan.
- Make sure the voltage and frequency of the network coincide with the technical values determined in the
technical plate.
- Electrical wiring HV150 AE model: according to scheme figure C.
Operation mode
 HV-150 AE Model
2 operation modes:
Mode 1 Fan Off – Shutter closed
Mode 2 Fan On – Working as air extract
Maintenance
- Before handling the fan, make sure it is disconnected from the mains supply.
- Clean regularly with a soft cloth moistened with water.
- Periodically check the state of the impeller.
- Do not clean with pressure water jet.
Removal from service, disposal and recycling
The CEE norm and our commitment to future generations require us to recycle waste material;
please deposit all remaining elements of the packaging into containers for recycling, and take the
equipment that has been replaced to the nearest waste centre or your dealer.
Technical assistance
The extensive S&P Official Services Network guarantees competent technical assistance anywhere in
Spain.
If any anomalies are observed in the appliance, please contact any of the Technical Services on the list to deal
with your problem.
Any handling of the appliance by persons other than S&P Official Services will lead to the guarantee being
cancelled.
S&P reserves the right to make any modifications without prior notice.
the support plate (f), introduce the electrical cables through the clamp
11