MV Agusta F3 800 R MY23 2023 Manual Del Usuario página 227

To start the vehicle with the "Launch Control" func-
tion active, perform the procedure shown on the display:
• Pull the clutch lever;
• Engage the 1st gear;
• Rotate the throttle control full open;
• When the activation procedure of the "Launch Control"
function has been completed, gradually release the clut-
ch lever within 5 seconds to put the vehicle in motion.
• After 5 seconds have elapsed, the "Launch Control"
function is automatically deactivated; to apply it again,
4
the procedure must be repeated from the beginning.
WARNING: The "LAUNCH CONTROL" function
manages the power supplied by the engine,
while the release mode of the clutch lever
remains under the control of the rider. During
the starting phase, do not release the clutch
lever abruptly to avoid losing control of the vehi-
cle. At the same time, do not extend the release
phase of the lever excessively to avoid overhea-
ting and consequent damage to the clutch.
If the starting procedure has not been correctly
performed, "LAUNCH FAILED" appears on the display.
Close the throttle control and repeat the procedure from
the initial phase.
OPERATION
- 98 -
4