MSG Equipment MS005 Manual De Usuario página 16

English
Test bench MS005/MS005A
8. In case of failures in the operation of the bench, stop further operation and contact the
manufacturer or sales representative.
WARNING! The manufacturer is not responsible for any damage or injury to human health
resulting from non-compliance with the requirements of this user manual.
1. The test bench shall be operated by the workers qualified to work with certain types of
equipment and received appropriate training in the safe operation.
2. In case of a power outage, the test bench shutdown is mandatory when cleaning and lubricating
the bench and in emergencies.
4. To ensure electrical and fire safety PROHIBITED:
- connect the bench to the electrical network having faulty protection against current overloads
or not having such protection;
— use a socket without a grounding contact to connect the bench;
— use extension cords to connect the bench to the electrical network. If the socket is far from
the bench installation site, it is necessary to modify the electrical network and install the socket;
- operation of the bench in defective condition.
- Independently to repair and make changes to the design of the bench, because it can lead to
serious damage to the bench and deprive the right to warranty repair.
5. The units with a running drive must not be left unattended on the test bench.
6. While mounting and dismounting of a unit from the bench, to prevent arms from harming, be
more cautious.
7. It is forbidden to open the door to access the power part of the stand if the stand is connected
to the 400V power supply network.
8. The diagnosed unit must be securely fastened.
5.2. Preparing the bench for operation
The bench is delivered packed. Release the bench from the packaging materials, remove the
protective film from the display (if available). After unpacking, it is necessary to make sure that
the bench is intact and does not have any damage. If damage is detected before the bench is
activated, contact the manufacturer or the sales representative.
The bench has to be placed on the level floor, with the pivot wheels fixed from rotating (min. two
wheels) by the activating of the brake mechanism.
When installing the bench, keep the minimum space gap 0.5 m from the rear bench side - for a
proper air circulation.
16
5.1. Safety guidelines