MSG Equipment MS005 Manual De Usuario página 41

Code
SIG
(Digital) Input for voltage code setting on the
D
RC
L(RVC) (Regulated Voltage Control) Similar to SIG, with
11.0-15.5V. The control signal is supplied to the
L(PWM)
(Communication) Input for the control of
C
voltage regulator by engine control unit. Korean
Input for the control of voltage regulator by
С (G)
(Regulated Load Output) Regulator stabilizing
RLO
(Communication) The general references of the
physical control interface and alternator
COM
diagnostics. The protocols BSD (Bit Serial
Device), BSS (Bit Synchronized Signal) or LIN
(Local Interconnect Network) can be used
Direct reference to the control and diagnostics
LIN
of alternator through the protocol LIN (Local
Used for 24V alternators where one of the pins
PWM
The control of the operation of Valeo alternator
Stop motor
that are installed into the cars with the Start-
Mode
I-ELOOP system alternator control terminal
K
F1, F2
DF
Connection of the regulator with the rotor
FLD
67
Application
(Signal) Voltage code setting input
American Ford, similar to SIG
(Regulator Control) Similar to SIG
just the voltage variation range
terminal L
cars.
engine control unit. Japanese cars.
voltage control
within11.8-15V (TOYOTA)
Interconnect Network)
in the connector is marked as PWM
Stop option
(Mazda)
Rotor winding coil output
winding coil
English
User manual
Cable wire/
Type of
alternator
cable
SIG
RVC
C KOREA
C JAPAN
GC
RLO
COM
PWM
IStars MS-33039
I-ELOOP MS-33040
F/67 MS-33042
41