MSG Equipment MS005 Manual De Usuario página 17

English
User manual
Prior to the bench operation, connect:
- Storage batteries 12V that have to be located in the storage battery section of the bench (fig. 13).
The left door is opened with the keys (included to the supply slip). While connecting the storage
batteries refer to the power cable markings. If only one storage battery is connected just 12V
diagnostic mode will be available, 24V diagnostic mode will be unavailable.
Figure 13. Location of the storage batteries in the bench.
- Electric network 400V, for this purpose it is necessary to use the socket supplied with the bench,
inside there is a marking L1 L2 L3 N PE which must be observed when connecting the socket to the
supply network.
6. DIAGNOSTICS OF 12/24 V ALTERNATOS
The following common diagnostic steps are provided for all types of 12/24 V alternators:
1. Installation of the alternator on the bench and its fixation.
2. Installation of the belt on the pulley and its tensioning.
3. Connection of power wires to the alternator. For convenient connection, an adapter should be
screwed onto the positive terminal of the alternator for the connection of the power terminal B+.
4. Connect the diagnostic cable to the terminals in the alternator socket.
5. Select the appropriate parameters for the alternator test.
6. Diagnosis of the alternator.
7. Dismounting the unit from the bench.
17