Stihl TS 700 Manual De Instrucciones página 12

English
Starting
WARNING
Your cut-off machine is a one-person
tool. Do not allow other persons to be
near a running cut-off machine. Start
and operate your cut-off machine
without assistance. Follow the specific
starting instructions, found in the chapter
"Starting/Stopping the Engine" in this
instruction manual.
Do not drop start the cut-off machine.
Drop starting means pushing the
machine away from the operator, or
allowing it to drop toward the ground,
while pulling on the starter grip. This
method is very dangerous because you
may lose control of the cut-off machine.
Instead, to start the cut-off machine
place it on firm ground or other solid
surface in an open area and hold it
10
securely to the ground or surface.
Maintain good balance and secure
footing.
Be absolutely sure that the cutting wheel
is clear of you and all other obstructions
and objects, including the ground or
surface on which the machine is being
started. When the engine starts, engine
speed will be fast enough for the clutch
to engage the belt pulley and turn the
wheel. Never attempt to start the cut-off
machine when the abrasive cutting
wheel is in a cut.
Once the engine has started,
immediately blip the throttle trigger,
which should release the slide control to
the run position and allow the engine to
slow down to idle. The abrasive cutting
wheel should not rotate when the engine
is idling. If the wheel does turn, adjust
the carburetor to set the proper idle
speed. See the chapter "Adjusting the
Carburetor" in this instruction manual.
If you cannot adjust the carburetor to the
proper idle speed, shut the machine off
and take it to an authorized STIHL
servicing dealer for repair before using
the cut-off machine. For complete
starting information, see the chapter
"Starting/Stopping the Engine" in this
instruction manual.
WARNING
When you pull the starter grip, do not
wrap the starter rope around your hand.
Do not allow the grip to snap back, but
guide the starter rope slowly back to
permit the rope to rewind properly.
Failure to follow this procedure may
result in injuries to hand or fingers and
may damage the starter mechanism.
Important Adjustments
At correct idle speed, the wheel should
not turn. For directions on adjusting idle
speed, see the chapter "Adjusting the
Carburetor" in this manual.
WARNING
Do not use a cut-off machine with the
idle speed incorrectly adjusted. The
rotating wheel may cause injury. If you
cannot obtain the correct setting, have
your STIHL dealer check your cut-off
machine and make proper adjustments
or repairs.
Working Conditions
Operate the cut-off machine under good
visibility and daylight conditions only.
Wearing hearing protection reduces
sound perception. Be alert not to miss
voice or other audible signals from co-
workers or supervisors. Keep within
calling distance to other persons who
may assist in case of emergency.
TS 700, TS 800