Spark Arresting Screen In Muffler; Spark Plug - Stihl TS 700 Manual De Instrucciones

English
Spark Arresting Screen in
Muffler
In some countries, the mufflers are fitted
with a spark arresting screen.
If engine performance deteriorates,
N
check the spark arresting screen in
the muffler.
WARNING
Wait until engine has cooled completely
before performing the following
operations.
Versions
There are two different spark arresting
screen versions in the muffler.
Spark arresting screen fastened
–
with clip
Spark arresting screen fastened
–
with screw
Spark arresting screen fastened with
clip
Use a suitable tool to squeeze ends
N
of clip (1) together and then lift the
clip away
Remove the spark arresting
N
screen (2) from the muffler
46
Clean the soiled spark arresting
N
screen
If the screen is damaged or heavily
N
carbonized, fit a new one
Refit the spark arresting screen in
N
reverse order of steps
Spark arresting screen fastened with
screw
2
1
Undo screw (1)
N
Pull out spark arresting screen (2)
N
with a suitable tool
Clean the soiled spark arresting
N
screen
If the screen is damaged or heavily
N
carbonized, fit a new one
Refit the spark arresting screen in
N
reverse order of steps

Spark Plug

If there is a loss of engine power, the
machine is difficult to start or runs poorly
at idle, first check the spark plug.
Install a new spark plug after
approximately 100 operating hours or
earlier if the electrodes are
eroded/corroded.
The wrong fuel mix (too much engine oil
in the gasoline), a dirty air filter and
unfavorable running conditions (mostly
at part throttle etc.) affect the condition
of the spark plug. These factors cause
deposits to form on the insulator nose,
which may degrade performance.
Removing the spark plug
Switch off the engine – move stop
N
switch to STOP or 0
Unscrew the screw (1) and remove
N
cap (2) – screw (1) is secured in the
cap (2) to prevent loss
TS 700, TS 800