Engine Management; Adjusting The Carburetor - Stihl TS 700 Manual De Instrucciones

English
Remove screws (3)
N
Remove filter housing (4)
N
6
5
Pull main filter (5) out of the filter
N
housing
Set choke lever to c
N
Remove the auxiliary filter (6) from
N
filter base – ensuring that dirt does
not enter the intake area
Clean the filter area
N
Remount main filter and new
N
auxiliary filter with the remaining
filter components
Refit filter cover
N
Tighten down the locking screw
N
Always use original STIHL air filters. The
high quality of these parts will ensure
trouble free operation, a long service life
for the engine and extremely long filter
life.
44

Engine Management

Exhaust emissions are controlled by the
design of the engine and components
(e.g. carburation, ignition, timing and
valve or port timing).

Adjusting the Carburetor

Basic information
The ignition system of this cut-off
machine is equipped with an electronic
maximum speed limiter. The maximum
speed cannot be increased beyond a
specified limit.
The carburetor is equipped with a
factory-installed standard setting.
The carburetor has been adjusted for
optimum performance and fuel
efficiency in all operating states.
Preparing the machine
Switching off the engine
N
Check the air filter – clean or replace
N
it if necessary
Check the spark arresting screen in
N
the muffler (present only in some
countries) – clean or replace it if
necessary
TS 700, TS 800