Stihl TS 700 Manual De Instrucciones página 35

Connecting the water connection
3
1
2
1
Insert the longer banjo bolt (1)
N
through the connector (2) of the
water attachment – observe the
position of the connector
Insert the square nut into the guide
N
in the guard and hold it in place
Fit the support with the longer banjo
N
bolt on the adjusting lever (3) –
screw in the banjo bolt and tighten
with the combination wrench
TS 700, TS 800
Checking the adjustment range of the
guard
Rotate the guard forwards and
N
backwards as far as possible –
adjustment range (A) must be
limited by the stop pin
Continue as described in the chapter
"Tensioning the V-belt".
Inboard mounting (TS 700)
Disassemble the abrasive wheel
N
(see "Fitting / replacing an abrasive
wheel")
Remove the water attachment
N
Remove the adjusting lever
N
Slacken the V-belt
N
Remove the V-belt guard
N
Remove "support with guard"
N
Preparing the "support with guard" for
inboard mounting
1
2
Unscrew the screw (1) of the limit
N
stop (2)
A
Remove the limit stop (2)
N
Unscrew the stop pin (3)
N
2
1
Turn the guard so that it is in the
N
position shown (see picture)
Screw in and tighten the stop pin (3)
N
Insert limit stop (2) – align the hole
N
in the limit stop with the hole in the
bearing
Insert and tighten the screw (1)
N
Install the adjusting lever
N
Mount "support with guard" – guard
N
on the inboard side
Install the V-belt guard
N
Connect the water connection
N
English
3
3
33