Cleaning And Maintenance - Cuisinart CPC-400 Serie Manual Del Usuario

CLEANING AND
MAINTENANCE
1. Unplug the power cord before cleaning.
2. Clean the outer body with a soft cloth, such as a
paper towel or microfiber cloth. Do not immerse
the outer body in water or pour water into it.
3. Remove the sealing ring assembly (Part #4) from
the inside of the lid by grasping the knob and
pulling. Set aside.
4. Remove the pressure limit valve (Part #1)
(see figure 9) from the lid by gripping and pulling
firmly upward. Rinse with warm water, and dry.
9.
5. Rinse the upper and underside of the lid
(Part #13) with warm water, including the air
escape on the underside and the red float valve
(Part #2). Dry completely, and replace pressure
limit valve (Part #1).
6. To clean sealing ring assembly, carefully remove
sealing ring assembly (Part #4) and clean with a
dampened cloth or microfiber cloth. Do not use
chemical cleaners. Wash metal plate with warm,
soapy water, dry thoroughly and replace sealing
ring or place in the dishwasher.
7. To clean the rubber grommet in center of sealing
ring assembly, carefully remove it, clean it, and
replace it.
8. Replace sealing ring assembly in lid. BE SURE
KNOB FACES OUT (figure 10) and "THIS SIDE
OUT" is facing you.
10.
9. Cooking pot is dishwasher safe. To hand-wash the
pot, use warm, soapy water and wipe dry. Be
careful not to damage the inside coating.
Never use harsh chemicals or scouring pads
or metal utensils.
NOTE: If scouring is necessary, use a non-
abrasive cleaner or liquid detergent with a nylon
pad or brush.
10. To clean the condensation collector, remove and
clean it with warm, soapy water, then reinstall it
(figure 11).
11.
NOTE: Condensation may collect on the bottom
rim of the lid. Liquid will collect on the top of the
base and drain into the condensation collector.
11. Any other servicing should be performed by an
authorized service representative.
8