Steering Angle - SICE A 92 Manual De Instrucciones

The tables below provide a list of the icons available in the windows, with a list of options
(menus for skipping between windows) and the description of the relative functions.
SYMBOL
Data summary:(Displays the window which summarises the adjustment data for
the current vehicle).
Databank: (Displays the window to select a vehicle from the databank).
Databank Summary: (Displays the window with the adjustment data for the
current vehicle, taken from the databank).
Steering angle: (Displays the window to carry out
measuring caster, king pin, included angle and maximum steering angle).
Rear Axle: (Displays the rear axle adjustment window).
Front Axle: (Displays the front axle adjustment window).
Ballast and fuel: (Displays the window for ballast location and fuel quantity.
(only available for vehicles which require ballast and/or known quantity of fuel).
Previous jobs (Displays the window containing the list of jobs saved previously,
to allow comparison with the current measurement).
Toe curve: (puts into execution the toe curve adjustment procedure).
SYMBOL
Demo: (Sets the aligner program in demo mode, without using targets).
Crooked Steering Wheels: (Starts the crooked steering wheel adjustment
procedure).
Technical Assistance: (Displays the diagnosis window to set-up the targets, to
read the settings enabled in the smart card).
Job Count: (Command to run the visualisation of the jobs performed by the
wheel aligner; the visualisation is protected with a password). This function is
visible only if enabled in the wheel aligner general set-up.
DATA BACKUP Procedure: The aligner can "Save data" in any valid disc (Hard
Disk, USB support, etc.). The Program manages data storage and keeps
available the last five (5) saves on the local disc drive (Disc C, Disc D, etc.
corresponding to the permanent disc drives (Hard Disk) installed on the PC).
MENU AVAILABLE IN JOB STATUS
FUNCTION DESCRIPTION
MENU AVAILABLE IN SERVICE STATUS
FUNCTION DESCRIPTION
67
the steering lock for