Operator Record Window; File Data Modification Window; File Data Input Window - SICE A 92 Manual De Instrucciones

To access this window, press the F8 key from the job record input window.
It displays the list of operators saved on file.
To make the selection, proceed as described in the "General considerations" section.
The following keys are active in this window:
- F1 displays the on-line "Help" function
- F2 goes back to the previous window
- F3 (or "Enter") confirms selection of an operator and advances to the window which displays
the operator's data.
- F5 prints the complete list of the operators stored in the file.
- F6 modifies the data of the operator selected from file
- F7 deletes the selected operator from file
- F8 enters a new operator on file
- F10 goes back to the job record input window.
The modification screens refer to:
- Vehicle makes in databank (makes entered by the operator)
- Vehicle models in databank (models entered by the operator)
- Customers on file
- Vehicles on file
- Operators on file
To make a modification, proceed as follows:
- select the field to be modified using the "Tab" or "Shift" + "Tab" keys (if the window contains
more than one field)
- enter a new character/value over the letters or numbers of the selected item
- re-enter the correct value.
To confirm the changes made and exit this window, proceed as follows:
- press the F3 key; you will be prompted to confirm saving of the modified data.
- press F3 to confirm.
If you do not wish to confirm saving, press F2.
The data input windows refer to:
- Vehicle makes in databank;
- Models of vehicle in databank;
- Customers on file;
- Vehicles on file;
- Operators on file.
To enter the data, proceed as follows:
- select the field to be entered using the "Tab" or "Shift" + "Tab" keys (if the window contains
more than one field)
- type a character/value
To confirm the data entered and exit this window, proceed as follows:
- press the F3 key; you will be prompted to confirm saving of the data.
- press F3 to confirm,
If you do not wish to confirm saving, press F2.

OPERATOR RECORD WINDOW

FILE DATA MODIFICATION WINDOW

FILE DATA INPUT WINDOW

71