Toe Curve Window; Personalised Printout Window; Jack & Hold Program; 2-Target Mode - SICE A 92 Manual De Instrucciones

The window can be called up from the front axle adjustment window only, by pressing the F8
key, selecting the "Toe Curve" option from the list and pressing the F3 key.
It allows the manual toe curve measurement and adjustment procedure to be performed.
The "preparing vehicles for wheel alignment" window is displayed. Follow the instructions
indicated and press F3.
The toe curve adjustment window is displayed; adjust, then press F3.
The "preparing vehicles for wheel alignment" window is displayed again. Follow the instructions
indicated and press F3 to go back to the front axle adjustment procedure.
The following keys are active in the "preparing vehicles for wheel alignment" window and in the
"Toe curve" window:
- F1 displays the on-line "Help" function
- F2 goes back to the previous window
- F3 (or "Enter") goes to the next window
- F7 displays the vehicle adjustment window
- F10 goes back to the previous window.
Displayed at the end of a measurement cycle (fig. 27).
Used to set the advertising message that will appear on the printout, together with the number
of copies.
This program is started by selecting the corresponding F4 menu option from the wheel aligner
program starting window.
It allows the vehicle characteristic angles to be adjusted with the axle concerned lifted, by first
locking ("freezing") the value displayed for the lowered vehicle, so that the variations caused by
the lifting operation are ignored.
Follow the graphic prompts on the screen, described below:
- press F5 with the vehicle lowered to lock (freeze) the values;
- lift the vehicle;
- press the F3 key to confirm that the vehicle has been lifted;
- perform the adjustment;
- press the F5 key to lock (freeze) the values again;
- lower the vehicle;
- press the F3 key again to confirm that the vehicle has been lowered.
The following procedure allows you to align just the front axle of the vehicle. It is recommended
for caravans or vans for which it is not possible to mount the brackets and targets on the rear
axle, due to the fairing of the vehicle.
1) Mount only the front 2 target and clamps.
2) Select the mode ROC and continue.
3) Make the steering.
4) Adjust the front axle.
5) If necessary, make the second steering.

TOE CURVE WINDOW

PERSONALISED PRINTOUT WINDOW

JACK & HOLD PROGRAM

2-TARGET MODE

81