Glossary; General Wiring Diagram; Target - SICE A 92 Manual De Instrucciones

Find below a brief description of some of the technical terms used in this manual.
Characteristic Angles
This term refers to all the angles that can be normally measured on a wheel aligner (total
front/rear toe, left/right and front/rear half toe values, left/right and front/rear camber, left/right
caster, left/right king pin angle, and steering angle difference at 20°).
Clamp
Adapter from wheel and measurement sensor.
Equatorial plane
Hypothetical vertical plane that divides the wheels into two equal parts.
Turntable
This is a base mounting a disk on which the steer wheels of the vehicle are positioned.
Turntables reduce friction between the tyre and the ground to facilitate settling in of the
suspensions and to cancel measurement errors during steering turns.
The area between the disk and the base must be always clean. Do not oil or grease this area.
Infrared beams (IR)
Electromagnetic waves that are invisible to the naked eye.

Target

Measurement instruments that are applied to the vehicle wheels to measure characteristic
angles.
Transducer
Electronic component that converts a physical parameter into another type of parameter, e.g.
angle transducers convert angles into proportional electronic signals.
Mod. A 92
PN. 4-900248 (Fig. 40)
AP1 Personal computer.
AP3 Keyboard
AP4 Printer
AP5 Monitor
AP8 USB Protection Key
AP13 Motor interface box
AP16 Mouse
AP24 USB hub
BR2 Camera
FU Fuse 10 A T
HL1 LED board.
M1 Motor
GS1 Power supply
SA1 Switch
XS2 Multiple socket

GLOSSARY

GENERAL WIRING DIAGRAM

88