Rear Axle Measurement And Adjustment Window - SICE A 92 Manual De Instrucciones

• read the graduated scale on the turntables, the internal (left wheel) and external (right wheel)
maximum steering angle and enter the read values in the corresponding fields on the
relevant data input window.
• turn the wheels 10° or 20° to the right (relative to the centre position) until the "STOP"
message is displayed;
• wait for the data acquisition;
• turn the wheels further to the right until the steering wheel locks;
• read the graduated scale on the turntables, the internal (right wheel) and external (left wheel)
maximum steering angle and enter the read values in the corresponding fields on the
relevant data input window.
• turn the wheels back to the left to straighten the steering.
The full steering procedure implies the use of turntables with graduated scale, of suitable sizes.
At the end of the steering procedure, a screen is displayed, with icons indicating the operations
to be performed next:
Position the steering wheel with the spokes straight
Lock the steering wheel
Press F3 (Enter) to confirm and advance to the next screen.
At this point the system acquires and saves the "diagnosis" data for the vehicle, i.e. the values
describing the state of the vehicle prior to adjustment.
These values are then shown on the screen of the measurement data summary table.

REAR AXLE MEASUREMENT AND ADJUSTMENT WINDOW

Displays the measured angles for the vehicle rear axle and the adjustment reference tolerances
(fig. 13).
The values are continually updated to guide the operator performing the adjustment.
The following keys are active in this window:
- F1 displays the on-line "Help" function
- F2 goes back to the previous window
- F3 (or Enter): advances to the next window
- F4 sets:
 Unit of measurement
Toe angle

• Degrees;
• Length;
Setback and Track Difference

• Degrees
• Length
Length

• Millimetres
• Inches
Angles

• Centesimal degrees
• Sexagesimal degrees
Pressure

77